Inspection plan Master data

With this field you can indicate how often a sample is taken (set the interval: every n number of test items or units).
 
For 0, only one sample is inserted.
For example, if quantity is 1, and this value is 10, one sample is inserted. If the quantity is 10, one sample is inserted, and two samples if the quantity is 11, 15 or 20.
 
Alternatively, a quantity-dependent number of samples can be stored in a table. To do this, click the orange arrow left to the input field. See Measurement per

Note: If a QC plan is stored with a position, the "Measurement per" option is ignored. Only one sample is ever created, and further samples can be created as needed.

The serial number is then displayed in window "Samples per test".

 
The option is ignored, if the QC-inspection plan is stored in an operation. Use the option only for serial number related items. If all conditions apply, this option has a higher priority than "Measurement per".

The option is only active if the QC-inspection plan is stored in an operation. The total planned time is used to calculate the number of samples.

The option "Samples per" is ignored in this case.

Per sample: Measurements are indicated per sample.

Per measurement position: registration of samples per measurement position

All: both kinds of registration are possible

The setting affects the visibility of various buttons. With "per measurement position" the button "per sample" is hidden.

See Routing – QC-inspection plan

Can only be used, if active.

Note: If release is disabled, and the inspection plan is stored in an item, QC order creation might fail. At least one released QC inspection plan must be stored in the item.

See Item – Quality control

Note:

If the inspection plan is not yet valid and stored in an item, QC order creation might fail. At least one released QC inspection plan needs to be stored in the item.

See Item – Quality control