Rounding

Area

Description

General Rounding

Beas work with 6 decimal places

Rounding defined in SAP

if Beas create an SAP Business One, beas use the Rounding definition from SAP Business One

Bill of Material Rounding Type

The rounding rule can be defined here.

ConceptRoundingType

The following settings are available:

No rounding

There is no rounding

round up

The number is rounded up. The exact decimal place can be defined in "Rounding Dec."

Example:

You have defined 1 piece per 18: the factor is then = 0.055556

If you multiply 0.555556 x (17+1) = 1.000008

After this you apply a round up --> The final result is 2

round off

Rounding at 5

From 0,5 (1 Decimal place) or 0,5 (2 Decimal places) will be rounded up.
Lower will be rounded off

Examples:

Requirement	Decimal place	rounded
1,45	2	1,45
1,45	1	1,50
1,45	0	1,00 Note: Only the last decimal place will be considered. Thus there is no rounding up of the second decimal place.
1,49	0	1
-1,5	0	-2
-1,45	0	-1
-1,45	1	-1,5

multiple of

Always the multiple will be formed, which will be indicated in "Rounding Dec."

Example:

Order multiple of 4

4, 8, 12, 16 is counted

At quantity 3 is rounded to 4

At quantity 4 the quantity 4 remains unchanged
At quantity 5 is rounded to 8

Example:

Order multiple of 10

10,20,30,40 is counted

At quantity 1 is rounded to 10

At quantity 10 the quantity 10 remains unchanged
At quantity 11 is rounded to 20

Bom Rounding function

Examples

Example 1:

A palette per 100 pieces is required
Quantity of requirement corresponds 0.01 palette per piece. But at least one palette has always to be required and from 101 pieces even 2 palettes. The BOM position will be adjusted as following for this:

Quantity: 0,01
Rounding type: multiple of
Rounding Dec. 100

Example 2:

A half piece is required. because there is no half piece. It must always be rounded up to 0 decimal place because there is no half piece.

Thus a requirement of 0,8 will actually be rounded up to 1 piece.

The following setting occurs:

Rounding type: round up

Rounding Dec: 0

Note:

Negative statement of decimal places are not supported.

Rounding results are always in Inventory UoM.